epoxy floor coating

H70&1epoxy floor coating Component: By the modified epoxy resin, coloring pigments, physical pigments and curing agents, additives composed of high-solids land holdings and special floor paint.

Characteristics: 1, in dry or wet coating can be directly on the ground to achieve superior protective effect; 2, solid content was high, fast crosslinking can be thick coating can be a complete floor coating project; 3, resistant to moisture, acid - , alkali, salt and other chemical reagents, heat water quality, with excellent wear resistance and load-carrying performance.

Application: Applicable to factories, warehouses, garages, laboratories, commercial buildings and other places the quality of concrete stone pavers on the ground and the same materials such as decorative walls and protective coating.

Color: Group A were: Can a variety of colors, viscous liquid B were: light brown yellow transparent liquid density: 1.5 kg / l Theoretical Coverage: 1.5 kg / l thickness of dry film: 1 mm ratio: A: B = 10:1.2-1.6 the applicable time: oveer5℃:8 hr. 10-15℃: 4 hr.

20-25℃: 2 hr. curing time: Usually 8 hours, based on the need adjustable are "B copies of" use to enhance or slow down the cure speed.

Substrate surface treatment: 1, the substrate must be firm, clean, no oil, iron and steel substrate surface rust to reach Sa2.5 degreasing grade, non-metallic substrate surface, oil, apply solvent or detergent wash clean; 2, the ground surface if they are not formation or defects, etc., apply the paint with the special powder (component c) transferred into a paste body, will be flat on the ground Scratch touch of pressure.

Construction Technology: the construction method: Scratch - wiping 2,Coating process: (1) with Paint: Stir the first component A and said component B good.

In the stirring slowly adding the component B in component A, stir evenly ripening put it aside for 10-15 minutes after immediately after construction; (2) Construction steps: will be provided with a good paint dumped on the ground, with the scraper quickly its scraping uniform, flat, static leveling 10 minutes later, a little thinner in the paint spraying the surface pressure with the trowel wipe it again, so that it is more flat and smooth; For a non-slip effect, you can even sprinkle the top layer of paint film Dong sand or corundum, with the trowel flat pat until the film actually 1000, the top and then a thin coating layer of the paint coating that is completed, maintenance can be used after a week.