Jointing Compounds

Natural gypsum powder mixing with kinds of additive, makes high quality and environment friendly product for commercial and residential purpose.

USE:

Used for plaster wallboard finishing and texturing. Do not mix with other material.

If the joint compound is dry,carefully add water to read the desired best way is 1kg jointing compound with 550ml water.

USE:

Used for plaster wallboard finishing and texturing. Do not mix with other material.

If the joint compound is dry,carefully add water to read the desired best way is 1kg jointing compound with 550ml water.

1,Apply the compound into any gap between the boards and fill the a piece of tape and press into the joint.cover the tape with the compound,and remove the redundtant,make sure the joint keep the same level with the surface,the first joint’s width is 100-120mm.

2,After the first coat is set and and dried apply a further coat,extending 50mm to 60mm on each side.Ensure that the coat is tight and featured into the board surface.

3,Once the second coat is set and dried apply a final coat extending 50mm to 60mm on each side ,ensure that it is tight and featured into the board surface.

4,After the final coat is set and dried ,the joint should be lightly sanded using 120 grit paper held in hand or pole sander.

APPLICATION:

The compound should not be used in temperatures above 45°C or below 0°must be applied over every wallboard ensure an adequate adhesion of the compound the tape must be firmly pressed against the board using a hammer head joint knife,uniformly distributing the compound.Likewise,apply multi-used compound over screw heads and plastic or metallic obtain better results,apply two or three compound layer over the tape.Clean excess compound off the board before it sure that dry compound does not come into contact with the remaining mixture.

PRODUCT DETAILS:

Packing:In SH-F Bag

Weight:5kg/bag

State: Powder

Stocking:Store off the ground and in a dry environment,for the one haven’t used off seal to store.

WARNINGS

When mixed with water,this material hardens and becomes very hot sometimes not attempt to make a cast enclosing any part of the body using this material.Failure to follow these instructions can cause severe burns that may require surgical removal of affected tissue or amputation of can cause eye,skin,nose,throat or respiratory irritation.Avoid eye contact and inhalation of dust.Water eye eye contact occurs flush thoroughly with dusty,water a NIOSH/MSHA approved respirator.Prolonged and repeated exposure to respirable crystalline sillica can cause lung disease and/or lung proper ventilation to reduce dust not ingested call physician.

 
Roney
Baier Gypsum Building
8618753957896