Fire-Resistance Hydraulic Fluid (Malaysia)

LUBRICAST 902LPC is the newest water glycol fire resistant hydraulic fluid formulated specifically for end users who require a phenol response level of less than 100 parts per billion (PPB).

LUBRICAST 902LPC raw materials have been carefully selected to provide a phenol response level of 60 PPB maximum while maintaining excellent lubricity, shear stability, rust protection and corrosion resistance. LUBRICAST 902LPC conforms to ASTM D-2882 and is factory mutual approved.

Benefits: The major benefits of LUBRICAST 902LPC include: (i) Exceptionally low phenol response levels for ease of disposal (ii) Excellent rust and corrosion protection which eliminates down time and wear on the system (iii) Factory mutual approval which enables fluid to be used in critical operations (iv) Conformance of ASTM D-2882 which enables fluid to be used in demanding operations without fear of excessive pump wear Applications: LUBRICAST 902LPC is designed for use in high pressure applications where fire resistance, conformance to local waste treatment regulations and good pump life are required.

Lubricast 902 LPC is especially well suited for die casters, foundries, steel mills and mines. Fluid Compatabilities: LUBRICAST 902LPC is compatible with most kinds of pumps including vane, piston and gear type units. LUBRICAST 902LPC is safe to use with most packing and seals except polyurethane and silicone.

Cork shaft seals should be replaced with Buna N or other synthetic rubber. Leather packing should be avoided; zinc or cadmium plated components should not be used with LUBICAST 902LPC. Care and Maintenance: To keep LUBRICAST 902LPC operating at maximum performance levels, periodic monitoring should be conducted.

Percent water level and alkalinity should routinely checked to eliminate problems with fire resistance, viscosity variations or rust. Water content can be determined with the use of a refractometer or the Karl Fisher titration procedure. Alkalinity testing should be determined by titration.

Product Specifications: Appearance: Clear red liquid Viscosity (SUS 100oF):200 SUS PH:9.6 Specific Gravity:1.09 Pounds per gallon:9.03 Freezing point: -55oF Percent water:40% Flash Point (F): Contains water Fire Point (F): Contains water ISO Particulate:16/12 max Reserve Alkalinity:210 LUBRICITY AND WEAR CHARACTERISTICS A.

ASTM D-2882 VICKERS PUMP TEST Test Conditions: Pressure, psi:2000 Sump Temperature, F:150 Pump Speed:1200 RPM (8 gpm) Test Period, hrs:100 Test Results: Cam Ring:18 mg Vanes:7 mg Total wear on ring and vanes:25 mg B. MODIFIED ASTM D-4172 FOUR BALL WEAR TEST Test Conditions:1200 RPM,1 HR, RT.

Load vs Scar Diameter, mm: 7.5 KG 0.40mm 20 KG 0.50mm 40 KG 0.60mm C. MODIFIED ASTM D-2670 FALEX-PIN & VEE BLOCK WEAR TEST Test Conditions: Direct Load 2000 lb. Pressure Steel Pin & Vee Block Total Wear:65 mg D. DIE CAST MACHINE Typical Operating Pressure:2000 psi Withstands continuous pressure:3000 psi Withstands spike pressure:5000 psi