FDI-01 FALLING DART IMPACT TESTER

FDI-01 Falling Dart Impact Tester is applicable in the impact result and energy measurement of the falling dart from a certain height against plastic films and sheets with a thickness less than 1mm, which would result in 50% tested specimen failure.

CHARACTERISTICS Micro-computer calculation, LCD display and Manu interface; Two test methods integration: A & B.

Built-in observation light; Pneumatic specimen clamp and release; Falling dart electromagnetic suspension and automatic release; Two start modes: Manual and foot-pedal; Automatic testing status judgment; Multi-units result display and printing; Mini-printer; RS232 interface; Network transmission interface for LAN data management and Internet data transmission.

PRINCIPLE At the beginning of the test, choose test method, and estimate an initial mass and Δm. Start test. If the first specimen fails, decrease the mass of the falling dart by decreasing weight of Δm. If the first specimen is not a failure, add the mass of the falling dart by increasing weight of Δm. Test as the same.

In brief, increase or decrease the Δm according to whether the former specimen is a failure or not. After 20 specimens, calculate the total number of failure specimens N. If N equals to 10, test over. If N is less than 10, add specimen and continue to test until N is equal to 10.

If N is more than 10, add specimen and continue the test until the number of non-failure specimen is 10. Then the tester calculates the test results automatically. according to special formula.

TECHNICAL INDEXES Test Method: A, B (Optional) Test Range: method A: 50~2000g method B: 300~2000g Accuracy: 0.1g (0.1J) Specimen Clamping: pneumatic Gas Source Pressure: 0.6MPa (Users provide gas source themselves) Inlet Size: Ф8mm polyurethane pipe Specimen Size: >150mm x 150mm Power: AC 220V 50Hz Net weight: 70kg Dimensions: method A: 500mm(L) x450mm(B) x1320mm(H) method B: 500mm(L) x 450mm(B) x 2160mm(H)

STANDARDS ASTM D1709, ISO 7765, JIS K7124, GB 9639

CONFIGURATION Standard: method A configuration, mini-printer Optional: method B configuration, professional software, communication cable Note: gas inlet of this tester isФ8mm polyurethane pipe; users provide compressed air themselves.