Die-Board Laser Cutting Machine (XYP- 300W)

infosunnyok[at]163[dot]com or sunny.gblaser[at]hotmail[dot]com

This machine fittest to cut MDF material. It can cut the MDF completely/full depth cut. And there is almost no Charring Layer. The cutting effection is very good. This machine has two laser heads. One laser head is above the working table, the other one is below the working table. When working, these two laser heads cut together. It can cut materials completely one time. And the cutting slot is uniform.

The motion table is made by 50mm cast iron. It uses the Taiwan original Wire Rod drive device. So, the machine's weight is over 3000kgs. It won't variable. This machine adopt best laser tubes. The working life is long. This machine adopt LeiSai(brand) dirven device. So, the machine's stability is high, the cutting percision is good. And it can resisstant the high temperature. The anti-jamming is also very good.

This machine is mainly used in cutting mould industry, rubber mould industry and the glass, wooden plates, die-board industry.

The machine's advantages. 1. It can cut 18MM, 20MM, 23MM, 25MM wood board one time. Especially the Die-board. The speed can be 30-35 metres within one hour when cutting 18mm thickness. And the cutting slot is uniform, the seam line of up and down is uniform. 2. When cutting, you needn't to add the other gas. 3. The 220V is enough for this machine.

It can start to work once you open the machine. You needn't to wait. The cost is very low. 4. The cutting software can compatible with the AutoCAD\CorelDraw\Adobe Photoshop.

5. The machine's stability is high. It adopt the flight path structure. 6. All the lens/mirrors are use USA material. It can ensure the laser power when it transmission. 7. It adopt the sealed constant temperature industry cooling system. It can control the water temperature percision. So, the laser tube can work well. 8. The machine's shell is made of high quality cold-rolled steel sheets. The desigh is reasonalbe.

The cutting area: 1500mmX1200mm laser intensity control Level :100 points Max. cutting speed: 800mm/second Memory: This machine itself has the memory device. It is 32M. So it can work without computer Cutting precision :± 0.1mm Support Formats :DXF, DST, BMP, PLTetc. Drive mode: AUTOCAD, CORELDRAWstep system Max. cutting thickness: 30mm Working voltage :220V± 10% 50HZ