Cubic Boron Nitride Cutter

• High hardness,good wear resistance,little coeficient of friction and good ashesiveness resiistance
• The hardness of glomerocrys cubic ammoniate boron is HV4500,the hardness of glomerocryst diamond is higher than HV6500,which is greatly higher than hard alloy,it has good wear resistance,the abrasive resistance of tool made from it is about 50-200times of carbide cutter.Glomerocryst diamond cutter mostly used for high precise processing of non-ferrous metal(copper,aluminum alloy),it is also fit for finish cutting of nonmetal such as porcelain,synthetic fibre.Cubic ammoniate boron cutter is fit for the processing of high hardness ferrous metal and alloy(e.g.Quenching steel and chilled cast iron),the hardness of workpiece is above HRC50
• High machining accuracy Can get high dimensional accuracy and good surface roughness to realize using vehicle to replace milling
  
• High productive efficiency The speed of cutting is far higher than hard alloy cutter,the times of too changing is greatly reduced and the quality of the product is stable
• Low comprehensive cost of cutter

times and hours of shutdown reduced makes the output of production line raised and the waste products decreased
running cost of equipment,electricity,labour and management costs are reduced
the sistuation of fitting for use PCD and PCBN cutters,if use it in prooer way,the total cost of production and unit piece processing is usually lower than processing cost of other cutters.

We would provide different series of turning tooling, Screw-on insert and Carbide Insert,such as TNGA Insert, DCGW Insert,CCMT Insert, CNMA Insert, HEEN Insert, SCGW Insert, SNMA Insert, SPGN Insert, TNGN Insert, TNMA Insert, VNGA Insert,PCD Insert,PCBN you have any questions about TNGA Insert, DCGW Insert,CCMT Insert, CNMA Insert, HEEN Insert, SCGW Insert, SNMA Insert, SPGN Insert, TNGN Insert, TNMA Insert, VNGA Insert,PCD Insert,PCBN Insert.