ASTM F1140 Leak and seal strength tester

ASTM F1140 Leak and seal strength tester principle The three test modes of the positive pressure method, which Burst Strength Tester satisfies are as follows: A. Burst Test: Burst Strength Tester internally pressurizes the packages until the package fails. The test pressure is the maximum pressure detected before the package fails. B.

Creep Test: Pressurize the package internally to a specific pressure and maintains this pressure for a specific time. The test measure is pass/fail. C. Creep to Failure: The package is creep-tested and held until the package fails. The pressure setting is higher than that of the creep test to ensure the package fails in some time.

The measure is the time until failure. Features 1. Three test modes of burst, creep and creep to failure are available on Burst Strength Tester. 2. PLC programmable logic controller realizes precise pressure and time control. 3. 7 inch TFT touching screen for convenient parameter setting and test operation. 4.

Multiple groups of test parameters can be save to avoid the repetitive setting time. 5. Test result auto statistics and storage. 6. Dual test methods of restraint distension and unrestraint distension 7. Program customization available.

ASTM F1140, ASTM F2054 Specifications Pressure Range 0 ~ 600 KPa; 0 ~ 87.0 psi (Standard) Inflating Head Φ4mm (Standard) Gas Pressure 0.4 MPa~0.9 MPa Port Size Φ6 mm PU hose Dimensions 400 mm (L) × 270 mm (W) × 180 mm (H) Pedestal Size 375 mm (L) × 275 mm (W) × 345 mm (H) Power AC 220V 50Hz Burst Strength Tester Standards ISO 11607-1, ISO 11607-2, ASTM F1140, ASTM F2054