8 wireless zones auto dial home alarm system

Model: PST-TEL204

1. 8 wireless zones LED display home alarm system

2. Multi modes optional for zones: close mode, quick mode, delay mode, emergency mode, intelligent mode and dual-tech mode

Delay mode: after the sensors triggered, if you did not disarm the alarm system within 30 seconds, then it will send out the alarming signal

Emergency mode: Usually we will set smoke and gas etc detectors as emergency mode

Intelligent mode: This mode usually set for the inside places where the people walking, under this mode, other zones detectors will alarm immediately if triggered. And the detectors under intelligent mode will not alarm

Dual tech mode (Optional): Means as long as two sensors are triggered within 30 seconds, the system will alarm, which can avoid false alarm

3. Anti malice interference function: The host can automatically identify the wireless interference. If the main host detects any wireless interference, then the siren will sound

4. Anti-decoding function: After you set this function, then all the wireless remote controllers can not disarm the alarm host

5. Intelligent micro-computer automatically controls dialing alarm system, in total it can pre-store 6 groups of telephone number, and it can be connected to monitoring alarm center. In order to immediately handle the alarms.

6. Emergency help: Wireless arm& disarm the system, and you can remotely control the alarm system via any telephone. Such as remotely monitor, remote arm and remote disarm etc

7. Mute/sound alarm optional

8. It has the priority to occupy the telephone line to dial out the alarming phone

9. Password protection. (The password consists of 4 digital numbers)

10. Can independently program the zone modes and zones' alert sound

11. This system can record your personal message for 10 seconds, which will not be lost after powered off

12. This system has telephone line anti-cut alarm function; if the telephone line is cut or shortcut, the siren will sound

13. Basic learning code, very convenient for adding extra detectors; if you want to add more extra sensors. You only need to program the learning command from the control panel, no need to set any jumpers code manually or by soldering

14. every time after powered on this system. It will automatically back to its previous status