Dear Sir,
Required HRC of SAE 1006 grade.
end users to make thin corrugated galvanised sheet with this material.
2) width and size: Qty
1.6mm x 800mm 3000Mt
1.8mm x 920mm 2000Mt
2mm x 920 mm 2000Mt
3) Coil ID 762mm and weight 12-20Mt max.
4) Pls quote CRF Chittagong, Bangladesh
5) Buyer,s Technical specifications
MATERIAL SPECIFICATION
Technical Specification followed SAE-1006
Physical Dimension and condition:
Tolerance on width + 1% of width, - 0% of width
Coils should be tight and square wound
Coil both ends should be square- No fish tail
Inner Diameter 762 mm, Outer diameter 2000 mm max
Coil Weight-Minimum 18 kg/mm of coil width but maximum to the extent of 20 MT (16MT to 20MT)
Telescopic and collapsed coils not acceptable,
Coils should be suitably strapped on eye and circumference.
Chemical Composition:
Carbon-0.05% max
Manganese 0.20 max
Phosphorous-0.030 max, Sulphur 0.030 max
Silicon As minimum as possible, (should be Aluminum Killed)
Other Parameters
Hardness 55 60 HRB max
Tensile Strength 27-30 kg /mm2
Camber, Thickness run down along the length and across the width as per SAE 1006
Wedge across the width Not acceptable
Defects-Free from major defects viz. Holes, Pits, Body and Edge Lamination seams slivers rolled in scale pitting etc.
TRAMP element : low
Reduction percentage to be confirmed by supplier
Looking forward to hear from you soon
Best regards
Khalid Iqbal
P.C Traders
440 Malaga Road, # 11
Oshawa, Ont
Canada L1J 1N8
Tel 905 435 0163 Fax 905 435 0107
E-Mail:- ***