I: Intensity, showing brightness 1E3C-E-OMB04-A03-00 Provide adequate facilities or wear appropriate protective equipment to avoid in-halation and direct contact with the eyes, skin, and clothing. Composition change during use may result in combustible

Changes the size of the current frame. In case of contact, immediately flush the eyes with plenty of running water for at least 15 minutes. Consult a medical specialist. [Image expansion]...Enlarges an in-frame image, with the center of the frame aligned

On the basis of the data (the machine data and the one for solder inspection) created on PT200, 1E3C-E-MMB0A-A01-02 this machine corrects the production data using the recognition device (PRU). Prepare the printed board to be used for solder inspection

3. When the message “Check the mark position.” appears, press [OK]. . Adjust the recognition mark position, then press [Re-recog]. [Lamp auto set] Sets the lamp values automatically. If you want to set the lamp values again before rerecognition, press th

. Lock it using the hand screw. 15 Perform the printing pressure teaching of the R side by repeating steps 7 to 10. 16 Enter a comment ( 4.5.4 Entering a Comment). 17 Turn OFF the servo switch. 18 Open the front safety cover. 19 Remove the teachi

+ [No], the squeegees open at their origin positions; then, remove UNLOCK the jig and press + [Run]. . When the teaching is complete, the squeegees open at their origin positions, and the message showing the completion of the teaching appears. .

4.5.2 Printing Pressure Teaching Flow ← Created on PT. Inputting the print conditions data Printing pressure teaching ← Adjusted automatically. Teaching is complete. 1E3C-E-OMB04-A02-00 Page 4-23 4.5 Printing Pressure Teaching 4.5.3 T

) ON ( ) OFF ( 5. Check the print position data. . If the print position is incorrect, correct the UNLOCK data and press + [Complete]. 6. Press [Register position]. To the next page 1E3C-E-OMB04-A02-00 Page 4-21 4.4 Print Position Teaching 7.

+ [PCB SideTeach]. . The screen is displayed. . The board recognition is carried out on the basis of the mask recognition data. 13. Repeat steps 5 to 9. . After the recognition teaching, the screen returns to the screen. 14. Press [Complete].

Alkali-resistant fiberglass mesh is woven by fiberglass woven roving as its basis mesh, and then coated by alkali-resistant macromolecule latex. After surface treatment, this alkali-resistant mesh has the features of fine alkaline-resistance, high strengt